Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a requirement which I am trying to simulate as below:[Host1]192.168.15.100------192.168.15.1[in ASA1 out]172.16.151.254------172.16.151.254[out ASA2 in]192.168.200.2------192.168.200.10[Host2]Both ASAs run 8.2. I can simulate this succes...
Hi again Jouni,A kind of limitation: host2 router had 192.168.200.10 as primary IP but also had a secondary IP address (172.16.151.1) from a previous setup. Once I removed that it worked.Many thanks for your help.RegardsRecep
Hi Jouni,You are right, with the NAT IP as the dest IP in "packet-tracer" the packet is allowed through ASA2. I still cannot connect from host1 to host2 though.RegardsRecep
Hi JouniAnother good spot! The diagram should be like this:[Host1]192.168.15.100------192.168.15.1[in ASA1 out]172.16.151.254------172.16.151.1[out ASA2 in]192.168.200.2------192.168.200.10[Host2]What I am hoping to achieve is from host1 I can ping 1...
Hi again,Reposting due to a couple of errors in my original post:I have a requirement which I am trying to simulate as can be summarised below:[Host1]192.168.15.100----192.168.15.1[in ASA1 out]172.16.151.254----172.16.151.254[out ASA2 in]192.168.200....
Hi Guys,We are also looking into ways to manage configs and keep inventory of WLCs/LAPs and to monitor them. We already use Tivoli NetView for monitoring and CiscoWorksfor inventory keeping and config management/backup etc and would like to integrate...
