Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear CISCO Team,
I have two ISP's setups both located on different cities. Yesterday, I have configured GRE Tunnel between them but neighbor relationship would't form between both ISP's routers. Neighbor is showing for moment into OSPF neighbor then ...
Dear CISCO Team,
I have Catalyst 2960, 24 ports switch, it isn't accessible from console. Screen shot is attached. Kindly, review and update accordingly.
Thanks,
Dear CISCO Members,
I am using cisco 3750-48TS at my core network. I experienced outDiscard problem on some interfaces. Output is given below. Kindly, view and update accordingly.
#show interfaces fastEthernet 1/0/1 counters errors
Port ...
There are many ways to configure your setup.
1) You can add a router between your converter and switch then Assign IP addresses to router interfaces and then configure your router as NAT Router and plug your ISP cable into one interface and another ...
It's clearly seen that port security is enable on all the interface. Kindly disabled port security from the interface on which you want to connect your internet line.
From your provided screen shots, I didn't deduced any thing related your problem. Kindly, provide the running configuration of Interface. Moreover, ports are err-disabled due to security violation. Kindly, check is there any security is configured on...
Dear Mr. Philip,
Tunnel Interface on both routers are UP and pinging each other whither I add static route or not.
tunnel Interfaces IP's: 172.16.10.1 - 2.
I can successfully ping from 172.16.10.1 to 172.168.10.2, but when I try to ping to 172.16.10....
