Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to ssh from a host behind the firewall to a IPSec VPN client's machine?I ran some tests. I was able to ping the VPN client machine if I specify the interface. I am wondering if there are special configuration that can make this happen...
I recently had 2 Pix 501 went into boot loop. Both pix can be boot up normally after powering down and wait for 10 minutes. However, if I had tried to boot it up either by reload or not disconnecting it from power and not wait long enough, it will on...
Can anyone let me know what is gaddr?I know that faddr is foreign IP address and laddr is Local IP address. But I can't make out what gaddr is?ThanksEppie
Is it possible to ssh into a host over webvpn? If yes, do I set it up as an applcation similar to setting up eg , remote desktop?Iam on ASA 8.3. Thank youu.
I am confused with the access-list requirement for IPS.IPS device will create dynamically generated ACL to the router in the event that a signature is triggered. It requires an existing access-list defined as Pre-block access list and an existing acc...
I had not been able to do that. I was unable to ping the VPN client machine if I do not specify the interface. I also make sure that the local firewall on the client is off.VPN is all working from the VPN client to the firewall's network.Ping from th...
No. This is on two different power supplies. However, it is on the same location. I noticed the problem on the first Pix 501. I swapped it with the second one in August. Now I am having the same problem on the second one.In this case, I am wondering ...
The router is a 2600 and ips is 4215. Currently I only have one set of access-list. That's why I don't understand how I can have a pre and a post access-list to be used by the IPS device.
