Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,I have a CIsco 2900XL Switch with Release 12.0(5)WC11 installed on it. In the commands, there are a global command for "Show access-lists" and a configuration command for access-list.I have the switch connected to a router using port fa0...
Hi Marcel,Yes the router has two ethernet interfaces. I should have clarified the entire situation. I'm using one of the interfaces to connect to my modem, and the other is connected to the switch. Originally I was using a Linksys WRT54G for my ho...
Thank you both for the answers. I would ask why the ios has the commands available toit, when it's not able to use them. But, I understand that switches deal with layer 2 and MAC Addresses, where routers deal with Layer 3 and IP Addresses.The probl...
