Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been setting up VPN connection using VPN 3005 for the Remote access vpn clients and site-to-site connections. I have no problem with the connections, the vpn clients could now connect to the private network through tunneled. But I want to limi...
I am new in VPN Concentrator and I am going to install it in our network. I put public IP for outside interface and private IP for inside interface of the VPN Concentrator. After enabling the NAT at the configuration settings under policy management,...
I have a web and DNS server inside the interface of my Cisco Pix Firewall. Both servers were map to an outside public address. Outside users could able to access our web server both via the domain-name and its equivalent ip address, but my inside use...
thank you for your time to reply...but, i need to define this on the network list, right? if so, to specify a single host, a wildcard should be use instead of mask...
Thank you for your reply!Just a follow up question, what necessary configuration do I need to add If I have a firewall (netscreen firewall) connected behind the VPN concentrator and I want to carry the policy configured in the firewall to my VPN conc...
Hi,I agree with the alias command because I did it with my other configuration, the only difference is that the DNS is in the outside network. Assuming that there will be no problem with the DNS server configuration, Is that all I need for this case,...
Sujit, hi!thank you for your response!!I have that configuration, but the problem still could not resolve the ip address of my we server into its domain-name.. Do I need fix something on the DNS server? If so, how could I do that to integrate it with...
