Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon!
I have a question about 802.1x. I set up a lab in which I configured mab authentication with 802.1x, but I have a weird behavior from my network controller. On the switch (4948e) I can see that the user is being authenticated and aut...
Thanks a lot Mr. Peter!!!!!!!!
I just tested the configuration that you said and it worked (by unchecking the checkbox in the PC).
When the checkbox int the PC was enabled, I was getting authenticated (on the switch) but I was getting "authenticati...
Thank you for your answer Mr. Peter, and for your advice!.
I changed the configuration on the switch and this is the output that I am getting:
(I also changed the Switch from 4948e to 2960 because I was getting the same result which I am going to s...
Thanks for your response Peter,
My network controller is a " Realtek PCIe GBE Family Controller".
No Mr. Peter, it is not working because is not being authenticated with the MAC address of the network controller.
I configured "dot1x pae authentica...
