Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all:I have a Cisco 7606 that I am testing with and it has the following modules installed:2 - WS-SUP720-3B2 - WS-X6748-GE-TXThe interfaces are up and the VLAN's are configured and active. The problem that I am running into is that when I assig...
Gentlemen:It was a power issue. I rebooted the 7606 and reset the power suppliesand now the line cards are in an ok status when I use the sh modulecommand. I am also able to see the ports assigned to the correct VLAN'sand the ports are active when ...
Talha:I have connected the Gi3/1 port to a server that is on the network and there is no light / activityon the NIC card or port. Here is the output from the sh ip int brief command:Cat7606#sh ip int briefInterface IP-Address OK? Method Status Proto...
Hello Talha:There is no light when I connect the ports I am using for the VLAN testing. Attached is the output fromthe following commands:#sh vlans#sh vlan brief#dir const_nvramThank you for your help,John
Jon:I have tested the physical ports but they do not even light up when I physically connect them. Here is the output from the sh moduel command: see attached.I really appreciate your help with this.
