Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I try to capture packets between remote access users in different profile/tunnel in order to find out where packets are droped,i try in this way: access-list test permit ip 192.168.1.11 192.168.2.11access-list test permit ip 192.168.2.11 192.168....
HelloI have pix and c3560. Behaind pix, on "inside" side is network: 10.0.1.0/24, behind c3560 is 172.26.39.0/24, c3560 has also ip 10.0.1.10. Ping between pix and c3560 is working in both direct. c3560 has default routing to 10.0.1.1 on pixI need t...
There is other place or way to check packets reachability between two remote access users or two s2s tunnels ? All of them use outside interface. I see that packets enter the tunnel on one end but i can't see this packets leave the end of second tu...
it's my topology:http://80.48.65.210/schemat/schemat.pngFor now pix1 have ipsec to pix2, s2s, and nat to internet. I think to make some change:- vlan 100 with 10.0.1.0/24 will be only between pix and c3560- vlan 200 remain without any change, defau...
