Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I apologize in advance for my very basic questions.I am switching ISPs in my company. Going from two T1s to a 10 meg up and down EIA Circuit.My target turn on date is this Thursday. I am not an expert on our (legacy) Cisco 501 Pix unit in any way. ...
husycisco wrote:I don think that the order would matter, but remove the interface IP last. If you first remove it, the configuration bound to it, which you intend to remove, may become corrupt or removed. Doing these settings prior to connect the mod...
husycisco wrote:From tools, select Command Line Interface. Then type clear arp then click send. Same for clear xlateThank you much. Tomorrow at 10 am EST is my big cut over.Just a few final questionsWhat order should I REMOVE the current IP settings...
After all the above changes, you would need to perform "clear xlate" and "clear arp".Thank you, Jennifer...Can I issue those commands in the PDM inteface somehow?
Thanks for the responses. I am using PDM, and not the CLI.I spent this afternoon going through and noting the current IP addresses that were listed ("Route", "Outside Interface", and "Host/networks")I was basically going to recreate the settings usi...
