Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,
I'm unable to remotely (WAN interface) access this Cisco C891F router using the underneath config.
telnet and ssh both works using the LAN interface. the error message is get is "Connections refused"
With debug ip packet i do see an RST packet...
Dear all.I have the following situation for which i appreciated some assistance...Inside a host 10.81.34.55inside interface 10.81.34.80using a VPN connection sessions from the datacenter (AMS) are setup to the 10.81.34.55 hosts (INDIA).These sessions...
We ran into bug CSCup75103.
Symptom:On IOS upgrade to 153-3.M2.bin & onwards, we cannot telnet/ssh the router where nat is configured.Conditions:This problem only exists if we have nat entry configured using ip which also exist on an interface, i.eip...
Mark,,
I have done as suggested.. No results..I believe it is related to either a NAT or routing issue (bug).
I have also delete the vlan 6 interface as that one was not required any more.
I have about same config, a little different router, older I...
LS,Using the following static I do get the desired result for one session...MC-India(config)# static (outside,inside) MIP-TEST AMS-PROD netmask 255.255.25$MC-India(config)#MC-India# sho natNAT policies on Interface outside: match ip outside host AMS...
Mike,sessions from 10.127.200.12 coming accross the VPN tunnel from the outside need to be translated into either 10.81.34.97 (port 6004) and 10.81.34.97 (port 6005) to the 10.81.34.55 server. This one only accepts sessions from 10.81.34.0/24 on the ...
