Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
We have just implemented Cisco ISE 2.0.1 and configured mab and dot1x policies. Unfortunately, there is one problem we are really struggling with.
Avaya 9650 phones are connecting directly to the switch and windows 7 clients are connected to ...
Hi Guys
I am trying to set up at TFTP backup on an ISE 2.0 , but the TFTP entry does not appear in the list of repositories after i configure it.
Has anyone else had this issue?
I've also been having problems with FTP backups.The repository is con...
Hi
A catalyst 3850 switch has VLAN 20 (10.18.4.32/29) defined on it, which has a gateway of 10.18.4.38:
BWY-01-D01#show ip int brief vlan 20Interface IP-Address OK? Method Status ProtocolVlan20 10.18.4.38 YES manual up up
An ISE server (SNS3415) ...
Hi GuysI am working on a "Small Network Deployment" of two Cisco ISE servers (SNS-3415-K9) in the Active/Passive config. In this deployment, one Cisco ISE node is functioning as the primary appliance. The secondary node supports the primary node and...
Hi guys
We are planning to deploy a Cisco ISE server to manage NAC for 300 users (Windows, WYSE, Avaya phones and HP printers). DHCP is running on the DC and the ISE interface has Layer 2 visibility of the whole network segment its managing.
We hav...
Hi
Long story short, Avaya phones are unable to send the EAPOL frame the switch is expecting when the client to disconnects from the phones hub. After capturing detailed evidence of the problem at Avaya's request, Avaya support formally refused to h...
So we have narrowed down the problem.
The phones a supposed to send an EAPOL frame to teh switch when a client is physically disconnected from a phone.
In the event of a successful dot1x authentication followed by a client disconnection from phone, ...
The FTP repository looks fine and displays the correct directory structure:
GLS-ISE-01/admin# show repository tftp% Repository not foundGLS-ISE-01/admin# show repository ftp% Repository not foundGLS-ISE-01/admin# show repository MK_FTP% Error readin...
just in case anyone else has this problem - it was caused by incorrect "ip radius source-interface <interface>"
instead of listing the physical port the ISE server connected to the switch on (Gi1/0/1) i used the management VLAN of the switch interfa...
Also, 10.18.4.38 is the gateway IP address of the VLAN that hosts the ISE servers, i dont understand why its listed in th eerror logs as device IP!
ource Timestamp2016-06-22 16:38:02.826Received Timestamp2016-06-22 16:38:02.841Policy ServerGLS-ISE-...
