Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There is a simple topology: a hub and some spokes. FlexVPN is woking between them with psk, BGP and no radius.Now I want QoS on the hub and spokes. The hub has an ISP connection with, let's say 100Mb and some spokes have 10Mb, some have 5Mb and so on...
Hi! The users have access to some servers through cisco vpn client. In ACL Manager I created the nesessary ACL and ACE and then I applied the ACL to the Group Policy for the users. The users now have access to some servers through cisco vpn client an...
Thank you very much. I am reading the document and it is what I was looking for.Another question: I want the tunnel IP address on the spokes to be always the same. Can I configure static IP on the spoke's tunnel interface or should it be pushed dow...
I tried tcp/3389. The remote user has RDP access to my computer, but I don't. I then changed tcp for ip. We both have an RDP access to each other. After changing back ip to tcp/3389, the remote user has RDP access to my computer and I don't have one...
Just for simplicity I changed permit tcp .... eq 3389 for icmp and removed my IP from the object-group. And again I can ping the remote host and the remote host can ping me.
This is an excerpt from Cisco Official VPN Cert Guide:You can configure standard ACLs to either permit or deny access from a remote user to an internal subnet or specific destination, or you can configure an extended ACL to either permit or deny a re...
