Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 site running off the same internet connection. One is the local network(Host) which it can access the internet with no problems. The second is coming from a T1 connection from the second office (Remote). This connection can make it to the...
John,Thank you for your assistance with this. You were right about the nat and after re adding the Access-list 101 permit IP 192.168.65.0 back to the Host router it started routing to the internet again.Thank you once again,Jonathon
John,Well this might be a different problem now. I just got a call from the Host location and they just told me they can not get to the internet since about 30 minutes after I left, which I left their location at 9:00 AM cst this morning. haha. So ...
John,I have added the inside nat to the tunnel interface on the router that connects to the gateway but still no luck. Do you have any other ideas?Thank you,Jonathon,
Here is the remote config. And yes the default route is configred to go thru the tunnel.interface Tunnel1 ip address 2.2.2.2 255.255.255.252 ip pim dense-mode keepalive 10 3 tunnel source Vlan2 tunnel destination 192.168.15.1 !!interface FastEtherne...
