Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
TLDR: What is the proper privilege configure level X command to enable a lower privilege level the ability to configure ip source binding? We need to grant personnel with lower privilege rights the ability to perform IP source binding. We have entere...
Should switchport block unicast be set on trunk ports? There is plenty of documentation about setting it in general and what it does with regards to not flooding unknown unicast traffic, but, I cannot find anything in specific about setting it on tru...
I have a network made up of Cisco 9300, 2960G/C/X/XR and a 3560CX. None of the switches are more than 7 hops away from each other and I can generally ping or SSH into any of the switches without a problem. I have been having issues lately with connec...
I am trying to understand how CoPP works on a single L3 switch that is configured for inter vlan routing and as the RP for our pim sparse-mode set up (between 2 VLANs only). There is no connection to an external network and there is no other routing ...
Various devices, mostly 2960 (15.2(7)E5) and 9200 (17.3.4b) series. The use case for Authentication is both local and via RADIUS. The number varies, greater than 1 but less than 15.
Thank you for the quick response. Setting the controls at the access level makes sense to me and I understand storm-control settings, but I am looking specifically for how block unicast will affect a trunk port. There is an organizational requirement...
Sorry it took so long to respond, here is an edited sh run (I have been setting "switchport block unicast" on the trunk ports as well, but currently have it removed): version 15.2
no service pad
service tcp-keepalives-in
service timestamps debug date...
STP is blocking one of the loops. I have removed the redundant link in the past to see if that was causing the issue but the problem remained.We have a total of 20 VLANs and use intervlan routing which is performed by the 9300.
