WCS - 7.0.164.0 and WLC - 7.0.98.0.For some reason, I am seeing rogue ap alert on WLC and am not seeing on WCS. How do I clean up database and sync with WCS and WLC.I am seeing same thing with coverage holes.- Allen -
I am currently running WCS 7.0.164 and 1130 series access point firmware 7.0.98.0.I am getting lot of complains from students that their laptops are not getting 5 bars signals. They are getting at least 1 or 2 bars with being disconnect frequency. ...
I am using site survey (EKAHAU) to do survey of one of dormitory building.I am getting different strength of signals from different access points (Cisco LAP 1131 )My questions are: Should I modify all access points to transmit at full power or leav...
I am running WCS with 2 WiSM and 4 4404 WLC.I just turn on CDP on all switches and router for switchport trace features on WCS.When I tried to turn on CDP on access points I get message to turn on Global CDP features. Problem seem to occur when I t...
We have similar problem at University here. Students and Staff are complaining that their MAC device are disconnecting especially iPad, iPhone, and iMac notebook. We are not sure if issues are with Cisco Wifi network (1130 series), or NAC (formerl...
Yes - you are right --- I was looking at wrong map. Setting power level to 1 on ap cause laptop to get 5 bar signals. 2 Neighbor access points between a room show tx power level at 6. Both access points are within 50 feet of each other.Do I ne...
I am seeing same things - AP 'hmb-s494a-ap' is being contained. This is due to rogue device spoofing AP 'hmb-s494a-ap' BSSID or targetting AP 'hmb-s494a-ap' BSSID. - Controller Name: WISM9-CAH-PRI-1We have 4 - WiSM and 4 4404 Controllers. All 8 con...
Let me explain the problem that I have on CDP issue - When I update access point to change ap name on Wireless Control System and click save, I get error message which is "Failed to enable Cisco Discovery Protocol, Global CDP on controller 10.128.14...