Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm quite new to the ACE appliance so my apologies if the questions don't quite make sense.We've had a requirement to put together a solution on an ACE where server A must always receive the connections. The only time that server B receives connectio...
Hi all, I'm having issues with a relatively simple sensor add. I recently had to rebuild the CW/MC server and am now at the stage of re-adding my sensors. However it fails with an error of "This sensor is version 4.1(5)S222 which is not known to the ...
Hi all, not sure if anyone has come accross this one before. When I log onto my IDS Sensors via SSH using a standard account the "show clock" command gives me a response one hour earlier than it should. The sensor is configured to use NTP and I suspe...
FYI I've resolved this issue. Contrary to popular belief the signature updates don't seem to be cumulative in all regards. Even though the MC was up to S225 it still needed to specifically be updated with S222 in order to allow the sensor import. Che...
Hi Pengke11, many thanks for your reply. I might be using a different MC to yours as I can't find any reference at the bottom of the Devices page. I've attached a screen shot for your reference. Thanks also for the link. I've found this document befo...
BTW, any idea on whether or not this issue is going to be resolved or has been resolved by any of the Sensor updates? Having to do this manually to 9 sensors plus incorporating NTP anytime we perform any time changes during daylight savings can get t...
Thanks for the replies guys. Full marks go to James for the resolution.The following lines did the trick:# clock set 13:18:00 November 1 2003# show clock detail*12:18:00 AEST Sat Nov 01 2003No time sourceSummer time starts 03:00:00 AEST Sun Oct 26 20...
