Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2911 router that has been in service for about 3 years now, and not really been touched in that time. There are 5 VLANs on the private side all on sub-interfaces of Gi0/0, these are configured with private IP addresses and "ip nat inside". ...
I am trying to move from a 5505 to a 5510 but i don't know how to get the VLANs configured how i need them. Behind the firewall are 2 servers only and nothing else. I don't want to add a switch because there are only 2 devices, the cost of the swit...
Hi Marvin,
I am already using that command on the existing 5505, to pass traffic between VLANs. As you can't add a VLAN interface on the 5510 like you can on the 5505, I have been trying to do it with sub-interfaces, below is my interface config and...
Thank you for your response, Marvin.
Apologies if I haven't explained well enough. The guest instances on the 2 servers are in the same VLAN(s) not separate VLANs. And I believe that is where this method will fail, unless I am mistaken.
Thanks.
