Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I am having the following issue with my home lab:Equipment: Cisco Catalyst Switch 2960-S POE 750W, Cisco 2951 Router running IOS 15.1I am having an issue with a few IP (POE) cameras causing my switch CPU to run high which causes connectivit...
Sooo..... I decided to look at my flash: and found that there was a newer IOS, c2951-universalk9-mz.SPA.154-3.M3.bin. I decided to reboot the router with the newer IOS and now the problem is gone! So going from c2951-universalk9-mz.SPA.151-4.M1.bin t...
Is there a way to fix the traffic/storm problem so that it doesn't cause an issue like this? It seems odd to me that this doesn't occur with my pfsense box (with same vlans) and yet the cameras are causing cisco gear to have issues. Here's also the s...
They use 15.4 watts. And not sure if you saw me state before that I was using my 2960 switch with a pfsense box. Had no issues what so ever. This all started when I began using the 2960 switch with the 2951 router. Seem like there is a broadcast floo...
I believe this is what you request: Switch Port 1 (Camera 1):MainSwitch#sh interface gigabitEthernet 1/0/1GigabitEthernet1/0/1 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 64d8.1407.1a81 (bia 64d8.1407.1a81)MTU 1500 ...
