Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,This will be a long post, as I have a couple issues to run past everyone as I am a newbie to Cisco switches (and it shows!). Our network is pretty basic: external 2501 router to ISP, PIX firewall, DMZ with 12 systems, and internal (token ring)...
I have a 'newbie' type question about the physical installation of a Cisco 4006 switch. I used the console connection to make the initial configuration changes. There are 2 GBIC ports, 1 console and 1 management port in the supervisor module. We are ...
Good Day to all,I have a spare 1604-R router with version 11.2(18)P which I want to put back on my network at a remote site. Is this a current version or should I upgrade to 12.1? I have done some searching on the CCO site and found information on th...
We are receiving multiple copies of the same inbound message, although not all messages are duplicated. In checking MSKB, I found article Q295725. It states that the cause is a PIX firewall using Mailguard. I tried the test for Mailguard (telnet to ...
Thanks for the prompt reply.If SC0 is for management (I thought ME1 did that), then what is used for the connection to the gateway (PIX)? SL0 is the only interface left.Carolyn
I had a suspicion that might be the case. So ... the external switching connection is the GBIC ports, right? In that case, I guess I need to get RJ-45 connectors for one of those ports.Thanks.
Hi,Can you elaborate on the uses of the 2 GBIC uplink ports which are on the Supervisor module?I have a dumb question, which I haven't found the answer for yet: If we are not using fiber, where is the connection to the PIX (which connects to our outs...
Brian et al,I just turned off MailGuard on our PIX. I delayed because our CIO was reluctant to "unprotect" our email server. However, we began experiencing extremely long delivery times from certain sources (primarily attbi.com) as well as duplicate ...
Thanks for the prompt reply.As this router is going to a remote site with 3 users, the boss decided the current IOS version is adequate. He didn't want to put more money or time into the project as we are going from token ring to ethernet at the same...
