Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In my enviroment we have a ASA5520 setup so that the inside interface faces the corp enviroment and the outside interface faces the lab, we basically want unrestricted access into the lab but controlled access out. I am trying to setup an IPSec tunn...
I am trying to setup a site to site vpn for testing and going through http://www.ciscosecrets.info/en/US/products/ps6120/products_configuration_example09186a0080950890.shtml still not able to establish the connection. I have attached the config's t...
Here are the config's for the 2 ASA's I am using. ASA8 is the one one that is non-standard were the outside interface is actaully the trusted side and the inside interface is the untrusted interface. Hopefuly this will help.
I agree that it's not the common way of doing things. I setup the tunnel in the standard way and traffic flows properly however when I change the security level of the outside interface from 0 to 100 and the inside interface from 100 to 0 traffic st...
Jill,Yes I was connecting the 2 outside interfaces to each other via a VLan on a switch to test the IPSec tunnel, but this was just part 1 of a larger project I'm working on. I actually have 3 ASA's that I'm setting up for remote locations that once...
Yes I am using ping to establish the tunnel. I have the debug set to 128 and I get no debug outputs to the console or do the log buffer. When I do a ping from the ASDM I get "Routing failed to locate next hop for udp from NP Identity Ifc:172.16.1.1...
