Hi!I am using freeswitch to connect to my SPA3102 which is registered using TLS. Quite often I see the following, which results in FreeSwitch ending the call with NORMAL_TEMPORARY_FAILURE.The syslog from the SPA3102 looks like this:Mar 19 19:58:15 x...
Hi!I'm having problems where the device fails registration using UDP but works with TCP. The response from the server is FORBIDDEN when I use UDP. I am only changing the transport, so I know the password is correct.The difference I see is that the A...
Hi!I was trying to use G726-32 codec, but I had some issues with one of my voip providers, together with FreeSWITCH. The problem appears to be the way the G726-32 codec is defined in the SDP parameters: INVITE sip:2010@192.168.1.120 SIP/2.0 Via:...
Hi!I have a problem with NAT and enabling NAT Mapping succesfully on the SPA3102 with firmware 5.1.10(GW).I have these set in the Voice/SIP tab:• Handle VIA received: yes • Handle VIA rport: yes • Insert VIA received: yes • Insert VIA rport: yes • Su...
Hi!I upgraded my SPA3102 to 5.1.10(GW) and now it is constantly restarting.The device comes on for maybe 15 seconds (enough to get an ip address), and then it restarts. I can not access the IVR system either.What is the way to fix this and stop the ...
Hi Again,This problem still exists and has been going on since I first posted. Has there finally been any response from Engineering or is this problem not going to be solved?Thanks!
Hi Albert,I still see this problem after shutting down all codecs not being used, and I do not see the "130 not in codec list" anymore. The fault is still there - see below from the syslogJun 22 19:27:35 92.xxx.xxx.xxx SIP/2.0 180 Ringing To: <2001...
Hi Alberto,I haven't heard anything for months regarding his fault. You stated in March that 'I've escalated this, as this has to do with TCP/IP interop.'Please can you give me some indication of the status of the investigation.