Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
After i set the traffic through the module and added the firepower device to the defense center . In analysis > context explorer , it shows me that no data.Can i see the traffic in the defense center?
Thank you
Hi all,
I created a service policy rules and enabled the ASA FirePOWER inspection,but i can't see any traffic in the firepower module.How do i duplicate the traffic from asa5506-x to the firepower module?Plus, how do i monitor the traffic in firepow...
Hi all,
My Virtual Defense Center running software version: 5.4.0 , but my firepower module is 5.4.1.
After i downloaded a Sourcefire 3D Defense center S3 Patch.The fightsight shown a update failed message as below.
Task Status Your task Installing...
Hi,
I have a firewall problem.Why i can't ping outside gateway 192.168.1.90?
My pc ip address is 10.10.1.1. I have set the PAT and ACL.Here is my topology as below.Please help.Thank you!
hi aastha,
Do you mean i should remove those command?
class-map global-classmatch default-inspection-trafficclass-map my-sfr-classmatch access-list ASASFRclass-map inside-classmatch default-inspection-trafficclass-map sfrmatch access-list sfr_redirec...
