About justin_m

justin_m · 01-09-2020

EDIT 13-Jan-2020 - I found an ideal solution for my issue with the help of the posts below and a lot of searching around the Cisco documentation. In my case, I wanted to get back to the WebUI's "Day 0 configuration" tool to attempt to configure the s...

justin_m · 01-13-2020

Reza,This message was hugely helpful, actually. I figured out an even better solution to my issue based on your explanation of the difference between NVRAM and flash memory on these switches. I edited my original post to outline what I did, and I was...

justin_m · 01-10-2020

Thanks, Reza.I believe you have answered my original question. I was able to add a username and password with a tutorial I found online, and it allowed me to login to the WebUI's Day 0 configuration tool.One follow-up question: would reloading IOS on...

justin_m · 01-10-2020

Lucas, while your reply was certainly helpful, it unfortunately was not a solution to the problem I'm having. I marked your post as Helpful but not as a solution. Thanks again!

justin_m · 01-10-2020

Thanks for your reply, Lucas. I had already performed the steps you listed (to set my computer's DCHP Client Identifier) prior to attempting to access the WebUI.

justin_m · 01-09-2020

Hi Reza,I apologize, I'm not sure which section of the document you linked would help me get the switch past ROMMON mode and booted completely. Would you be able to elaborate on that? (Also my ROMMON issue is actually on a separate, second switch fro...

Member Since	‎01-09-2020 10:19 AM
Date Last Visited	‎10-07-2024 12:01 PM
Posts	8

User Statistics

User Activity

C9300 Day 0 Configuration

Re: C9300 Day 0 Configuration

Re: C9300 Day 0 Configuration

Re: C9300 Day 0 Configuration

Re: C9300 Day 0 Configuration

Re: C9300 Day 0 Configuration