Greetings, I'm trying to add a new VLAN to a trunk port using the Cli on an FI switch. I can see the trunks through the nxos using show commands but I have to make configuration changes through the FI and unfortunately it's hot garbage. I didn't see this in the Cli guide but I'm using UCSM 3.0. The C220 servers are plugged into the FEX which is plugged into the FI which is plugged into the N5k I think. So I'm trying to get this new vlan added to all the trunks upstream using the Cli commands. Thanks in advance
... View more
Greetings, I want to ask what post steps need to happen when replacing a bad network adapter on a Cisco C220 via UCSM or the shell. I just replaced a fiber cable on a Cisco C220 server running ESXi and the link light flashes slowly but the Veth still shows link down and the FI shell under the nxos context shows "err-disabled on the Veth (upstream interfaces are fine). Additionally, the ESXi host shows disconnected within the DCUI and the vCenter. I'm guessing the physical adapter is bad unless it's some other UCSM madness but wanted to ask what post steps I have to take after replacing the adapter. The Fabric is end-host mode and uses pinning. The Cisco UCSM shows this. Affected object:sys/rack-unit-*/adaptor-1/host-eth-*/vif-800 vif down Description:Virtual interface 800 link state is down I was also having an issue trying to no shut the err disable Vethernet port on the server from the Fabric but If the adapter is bad then I guess it doesn't matter but is the below the correct command to run when after replacing the adapter? What else needs to be done? FI-B# /server/adapter/host-eth-if # set adminstate enabled.
... View more