Hi Guys,
Just wondering if i could get some help with setting up a port forward for a camera system using a cisco asa 5506
locally the server IP is 192.168.0.5
the camera system uses port 22609 via local host
i need to be able to access the came...
Hi AllIm having major issues with CCA2.1 when trying to Nat ports to an sbs server. I have tried this at a few different sites and most of the time the change wipes out the PPPOE internet connection. Sometimes I can log in using version 2.0 and repai...
Hi Grant,
i have attached the config and nat output, also the system information of the camera system which shows its using the local host and port 22609. I tried locally accessing the address with the public ip and ports and could not resolve eithe...
Hi Grant,
after adding the commands i still cannot seem to browse via public on the required port.
Not sure what else it could be. Do you happen to use skype might be easier to communicate if you have time to further assist would be much appreciate...
Hi Grant,
when entering object network OBJ_CCTV_22609nat (inside,outside) static Interface service OBJ_TCP_22609 OBJ_TCP_22609
i can only put the command in to the point of interface service but not the
OBJ_TCP_22609 OBJ_TCP_22609 part
after that...
Hi Grant,
when entering the command ; nat (inside,outside) source static OBJ_CCTV OBJ_CCTV_PUBLIC service OBJ_TCP_22609 OBJ_TCP_22609
i get the following error;
ERROR: Address (public ip) overlaps with outside interface address.ERROR: NAT Policy is ...