Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have over 100 700 series APs installed in several locations. Al the APs are in the same WLC (same running image). Almost all the APs are in FlexConnect mode. TheAPs are powered thru PoE provided by the switch. All the APs have the same allowed bit ...
I have a similar problem, but with 1532 APs, 8510 WLC and an 8.2.121 image.
Try to take the vWLC and the APs to 8.0.140 image. For me, this resolved the problem, at least temporary. I think it is a bug. I tried to find it on bug search tool, but with...
From what I saw in the config on the radio interfaces, the difference is that each AP emits in different channels and channel 1 has a slightly bigger transmit power than channel 6 an 11.
My problem is that there is a difference in what you can configure at the interface level in two similar APs.In one AP I have the following config:AP06(config-if)#power local ? <5 - 14> One of: 14 11 8 5 maximum Set power to allowed maximumAP06(...
Hello, I know all the datasheet data.My problem is that like that: I have two nearly identical 700 series APs, connected in the same switch that are behaving differently. One of them is emitting with full power at 20 dBm and the other with only 14 dB...
