Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a ridiculous problem, this 8.3 version is throwing suprises one by one...I have 2 interfaces Corp (142.63.52.221 / 27) and Collab (10.137.136.240 / 24) with the same securrity level 100. No NAT.I want to access from Corp to RDPSvr (10.137.136...
Need help in figuring out how to setup anyconnect VPN with VPN client NATed into internal network.There're a lot articles about opposite - how to disable NAT for vpn pool.I need to create VPN gateway to complex interna lnetwork, vpnpool is out of re...
I understood what was said, the only thing I'm wondering is WHY while all the traffic is allowed between interfaces putting one PERMISSIVE rule for a particular service block all other services.In other words if there are no rules ALL the traffic is ...
Thank you, that works through I have no idea what the logic it is - if permit same-security-traffic permit inter-interface wthout ANY other access rules ALL IP traffic is allowed in both directions!!!So much of security...And why in this case implici...
Sorry, it doesn't help.I know that by default traffic is not allowed, and don't want to change that.BUT it should be allowed be explicit access-list/access-group commands. I don't want to open everything (this's want happens when you issue command)...
