Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In attached configuration on asa5510 traffic will not pass through firewall from computers assigned to static nat. tested from ip 192.168.100.99 with dns,www and cannot ping hosts on dmz.
When I add an access list to allow a service group access through the firewall all traffic is blocked config posted below.: Saved: Written by enable_15 at 08:48:32.873 EST Tue Jun 3 2008!ASA Version 7.0(7) !hostname ciscoasadomain-name my.asa.orgenab...
I have not tryed this but you might try connecting the serial cable and connecting with hyperterminal then pwrcycle the unit and issue a break command to bypass login security. Not sure what break cmd is for this unit but some web searching may help....
I will keep that in mind but should this work setup the way it is now??Should I maybe put all hosts that need static nat on the dmz interface where the firewall is the gateway?
I checked the config I posted and you are correct seems that I must have deleted the static nat rule I was testing with I will have to verify the running config on the firewall then retest. Thank You for the response. I also have a question everythin...
This did not helpHave upgraded to 7.2 and can now ping to dmz but all access to wan is blocked on any host where a static nat rule applies ex. host 192.168.100.99 cannot access external webpages but host 192.168.100.33 can. Have also tested from WAN ...
