Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attempting to allow access for IPSEC VPNClient to management network. packet trace stops on vpn encrypt even through phase 7 states it is NAT EXEMPT, it says its still trying to NAT through a static. The only thing i can think of to put a nat exem...
We are looking to allow our remote VPN users to access one external IP address. Basically once the users authenticates when they try to access 202.1.56.19 they should be nat'd out through the firewalls external interface. Below is output from packe...
Hi All,I am trying to replace an apache proxy server that redirects traffic from 192.168.250.16(apache IP) to 10.195.23.13 (remote host)The IP of interface VLAN107 is 192.168.250.254The idea is to have clients connect to the Interface IP of the asa (...
I think it was getting the right address from the right pool but those acls for the L2L VPN i think was the problem. After clearing the SA its working fine now.I also added the /24 nonat acls as you suggested.Thanks again Jen
I have the VPN client connected. it autheticates fine but can't pass traffic. I have set up other Group-policys fine connecting to other VLANS which work.Is it possible to email you the config, it's rather large and from a security point of view im...
It doesn't appear to be NAT EXMPT even though the rule is there. I am correct here? Am I also correct is seeing it is trying to perform a static nat on return?Although I have run a tcpdump on 10.10.10.10 and dont see anything hit it...ASAPRIMARY(co...
