Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,i have this estranged situation: I have two ASA's 5520 in Active/Standby failover mode. After the software update from 8.2(1) to 8.2(2) one of NAT(PAT) rules in outside interface unexpectedly disappeared from startup configuration/running co...
Hi,can you tell me if its possible to control the amount of time of the VPN client connection after the connection in Cisco ASA 5520?ACL by time is one solution but its not scalable due to the fixed time that the user will need to connect.Regards,Raf...
Hello folks,this is my ASA 5520 failover output: This host: Primary - Active Active time: 1498 (sec) slot 0: ASA5520 hw/sw rev (2.0/8.2(1)) status (Up Sys) Interface outside (172.16.1.3): Normal (W...
Hello Federico,thanks for you reply.when i put the NAT rule again, everything works fine.There is an official report from Cisco to this behavior?Thanks you!Rafael Petter
I had the same issue with two ASA 5520 in Active/Standby. When the primary firewall goes down, only telnet/ssh access is allowed to the secondary unit. When i try to connect with ASDM applet to the secondary unit, the applet doesnt respond.I discover...
