Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, After months of 802.1x working perfectly in a small wired network, out of the sudden some things are not working properly. Here is what I am working with: Windows 10 using native supplicantC9300 24UX version 16.12.3aISE 2.6 (latest pa...
Hello all, I am having some issues with 802.1x deployment. I When I login into a workstation using my admin account it all goes well. Authentication and authorization works as planned, I get the Dacl from ISE and everyone is happy. The problem is tha...
Hello everyone, I am currently in the process of rolling out Dot1x in a small classified network. The network has the following: (12) Windows 10 Machines using native supplicant software(1) Cisco C9300 acting as the authenticator(1) Cisco ISE acting ...
Hello everyone, I have been working for a while on deploying 802.1x at work. It consists of the following: - Windows 10 workstations (using native supplicant software)- Cisco Switch 9300 16.12.2r (Authenticator)- Cisco ISE (Physical appliance) 2.6.0....
Hello,I configured a 802.1x deployment using a Cisco 9300 Switch Stack IOS 16.8.1a, Cisco ISE IOS 2.6.156 and Windows 10 workstations using windows supplicant software. The whole thing works... The supplicant is able to authenticate the user credenti...
Hello,Below is the output of the command. As you can see the ports shows "unauthorized" even tho it is passing the Authentication and Authorization in the ISE.sho access-session int Gi x/x details Interface: TenGigabit2/0/13IIF-ID:________Mac Addres...
Hello, Did you mean #Sh authentication Sessions detail? I will post the output once I have access to it again as it is air gapped network. Please hang tight I will post again Monday. Thanks
Hello, Those are the physical port configs. There are more lines in the config but those are the ones related to the Dot1x. The PRE-AUTH ACL has entries allowing the workstation to communicate with the domain controller, DNS, DHCP, TFTP and things li...
Hello, It is an air gapped network but here is what I have configured in the interfaces: switchport access vlan 100switchport mode accessip access-group PRE-AUTH inauthentication openauthentication order dot1xauthentication priority dot1xauthenticati...
Thank you for the info. I will go ahead and make some changes on the Policy sets and see if that makes the difference. I was thinking it had to do with the computer name but thank you for clarifying the "host" part on the name. I will get back to you...
