el 01-17-2013 05:19 PM
Hi Everyone,
i am having a bit of an issue. I have a group of 1142N APs that are controlled by a 4404 controller. After joining the controller i configured those APs with a location, a static IP and a Hostname.
The problem that i am facing is when the i check one of the switches CDP neighbors where one of those APs is connected, it is showing the hostname of the AP with the domain name of the WLC appended to it.,
Examples:
If the WLC domain is : .zain-equip.net
The AP hostname is configured as: USAMDAP011
Then the switch cdp neighbor where that AP is connected will show as: USAMDAP011.zain-equip.net
While i only want the AP hostname (USAMDAP011) to show as the cdp neighbor hostname.
is there a specific command on the WLC that can prevent it from appending the domain name to the AP hostname?
please advise,
Thanks
el 01-17-2013 05:36 PM
is there a specific command on the WLC that can prevent it from appending the domain name to the AP hostname?
Give it awhile. The extension will disappear.
el 01-17-2013 05:58 PM
Hi Khalid,
Telnet/SSH in to the AP and verify if you are able to see some thing like ip domain name , is so try removing the domain name from the AP. If you are using static ip on AP use below syntax.
config ap static-ip {enable cisco_ap ip_address net_mask gateway |disable cisco_ap | add {domain {cisco_ap | all} domain_name} | {nameserver {cisco_ap | all} dns_ip_address} | delete {domain | nameserver} {cisco_ap | all}}
I'm not sure if this will work so try doing it only for one AP.
Regards
Najaf
Please rate when applicable or helpful !!!
Descubra y salve sus notas favoritas. Vuelva a encontrar las respuestas de los expertos, guías paso a paso, temas recientes y mucho más.
¿Es nuevo por aquí? Empiece con estos tips. Cómo usar la comunidad Guía para nuevos miembros
Navegue y encuentre contenido personalizado de la comunidad