Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have an AMP for Endpoints deployment and I am having a difficult time tracking down documentation that explains the meaning of the events that are generated in the management console. Specifically I am seeing "Quarantine: Failed" and also "...
I have an incoming POTS line connection to an FXO port on a 1760 gateway. This POTS line is only providing -24 voltage rather than the normal -48 voltage. This seems to be preventing the FXO interface on the router from sending DTMF that is accepta...
I agree that our best bet is to use a PSK for the IPhone and most other mobile devices. In order to use fast roaming with 802.1x the client will need to support CCKM via CCX. While many non Cisco devices do support CCX I am not sure that the IPhone d...
I would also like to know what state the client is in per the WLC. If the client is in the run state I would think we have a client issue or perhaps a routing problem outside of the WLC.
Right, if we want to do dynamic VLAN assignment the only option is via RADIUS which then requires some type of EAP method for authentication. So from what I gather from the thread is that we cannot do 802.1x for authentication. This leaves us only wi...
Zappo,I would create two mobility groups, one per location. Make sure to also configure the mobility groups across locations as well in order to allow for proper AP fail-over. Specific to NAT there is no restriction to how many times you are able to ...
Amar,Since you are going to install the WISM2 you will be limited to where your chassis is physically installed. If we are operating under the assumption that all, or at least most, of the traffic sent to the WISM2 will eventually hit the data center...
