justin.chow 发表于 2018-10-25 15:21
能show下光口的配置嘛
这是2960x上49口的,3650差不多内容。虽然现在是duplex-full 但是电信说必须强制。因为电信将他们光纤设置为“全双工”时,插上我们的设备灯都不亮,完全不同,端口显示notconnect. 电信现在设置为“自适应"才通了。但是这个状态时他们说速率不达标,并且丢包率很高,他们一定要改回全双工
GigabitEthernet1/0/49 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is a0f8.493d.8db1 (bia a0f8.493d.8db1)
Description: uplink to SXXXX01 Core Fibre Optical
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseLX SFP
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 6616000 bits/sec, 1202 packets/sec
5 minute output rate 2800000 bits/sec, 808 packets/sec
154119699 packets input, 118989102148 bytes, 0 no buffer
Received 7780000 broadcasts (4504753 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4504753 multicast, 0 pause input