I have one question about L3 multicast
I have many multicast source input to Switch;
we detected the all of TS multicast stream PCR continuous count error by stream analyzer;
I check Switch logging that having one port down-up causes this problem,
In the test environment, I tested the down-up of G1 port ,about one minute later, I received multicast stream from G2 port which detected PCR error by stream analyzer.
Is this normal? Is there any way to fix this? Thanks.
--------------------------------------------------------------------
CISCO Switch Catalyst 3650 version 16.3.6
The config is that :
interface GigabitEthernet0/0/1
no switchport
ip address 10.101.20.1 255.255.255.252
ip pim passive
interface GigabitEthernet0/0/2
no switchport
ip address 10.101.20.5 255.255.255.252
ip pim passive
interface TenGigabitEthernet0/0/1
no switchport
ip address 172.168.2.1 255.255.255.252
ip pim sparse-mode
ip igmp static-group 239.0.100.1
ip igmp static-group 239.0.200.1
interface LoopBack0
ip address 192.1.1.1 255.255.255.255
ip pim sparse-mode
ip pim rp-address 192.1.1.1 override