附件文件可以使用,AP2800的ME镜像。
我在另外一个帖子看到了你的回复。应该还是升级后Country Code设置的问题,建议根据AP的型号,设置对应的Code。
控制器配置的话在Wireless-Country界面,ME的控制器,可以用命令修改:
(Cisco Controller) >config country CN
Changing country code could reset channel & RRM grouping configuration.
If running in RRM One-Time mode, reassign channels after this command.
Check customized APs for valid channel values after this command.
Are you sure you want to continue? (y/n)
(Cisco Controller) >show country
Configured Country............................. CN - China
Configured Country Codes
CN - China..................................... 802.11a Indoor,Outdoor / 802.11b / 802.11g
(Cisco Controller) >
试试如下操作:
(Cisco Controller) > config
(Cisco Controller) config > ap usb-module over-ride enable <AP-name>
(Cisco Controller) config > ap usb-module disable <AP-name>
检查:
(Cisco Controller) > show ap config general <AP-name>
如果关闭,会显示USB Module Status ............................................Disabled
实在需要的话,可以从如下链接尝试下载(仅供参考,Internet资源,谨慎选择)吧,下载完毕注意看看md5是否和官网的一致,以免文件损坏了。
https://www.4shared.com/get/4Ltg9DkMea/AIR-AP3800-K9-ME-8-10-151-0.html
另外:建议有新的需求或问题,还是在新的讨论里面进行吧,否则大家看不到你的问题,都认为这个问题已经得到了解决!
The USB port does not have any software support at this time.
Cisco Aironet 2800 Series Access Points, Getting Started Guide
我在另外一个帖子看到了你的回复。应该还是升级后Country Code设置的问题,建议根据AP的型号,设置对应的Code。
控制器配置的话在Wireless-Country界面,ME的控制器,可以用命令修改:
(Cisco Controller) >config country CN
Changing country code could reset channel & RRM grouping configuration.
If running in RRM One-Time mode, reassign channels after this command.
Check customized APs for valid channel values after this command.
Are you sure you want to continue? (y/n)
(Cisco Controller) >show country
Configured Country............................. CN - China
Configured Country Codes
CN - China..................................... 802.11a Indoor,Outdoor / 802.11b / 802.11g
(Cisco Controller) >
试试如下操作:
(Cisco Controller) > config
(Cisco Controller) config > ap usb-module over-ride enable <AP-name>
(Cisco Controller) config > ap usb-module disable <AP-name>
检查:
(Cisco Controller) > show ap config general <AP-name>
如果关闭,会显示USB Module Status ............................................Disabled
有个8.3.121的,https://upw.io/so/AIR-AP3800-K9-ME-8-3-121-0.zip~i
8.10.185没有找到。
你需要使用的feature是什么?据我了解,8.10.185并未增加新的feature。
There are no new features that are introduced in this release.