AP一直亮白灯

[xiayu57697]

思科AIR-AP2702I-H-K9端口没有输出 ，通电白灯常亮，这个状况怎么处理，有大侠见过吗

[YilinChen]

CONSOLE没有任何信息么？保修期内报修，过保了，就当废铁处理:P

[敏民]

boot检测没通过...有可能flash模块坏了.或者丢失低层启动文件

[xiayu57697]

YilinChen 发表于 2019-12-24 16:06
CONSOLE没有任何信息么？保修期内报修，过保了，就当废铁处理

没有任何信息 这个故障什么原因造成的，有三个都是这样的。

[xiayu57697]

敏民 发表于 2019-12-24 17:22
boot检测没通过...有可能flash模块坏了.或者丢失低层启动文件

什么输出都没有

[敏民]

以前也曾经遇到过1个ap.输出显示boot flam.这就是丟失低层启动文件..你这种情况更麻烦..送返修吧..

[Rps-Cheers]

这是AP2702的LED状态灯参考状态：

Table 1 LED Status Indications

Message Type	Status LED	Message Meaning
Boot loader status sequence	Blinking green	DRAM memory test in progress
DRAM memory test OK
Board initialization in progress
Initializing FLASH file system
FLASH memory test OK
Initializing Ethernet
Ethernet OK
Starting Cisco IOS
Initialization successful
Association status	Green	Normal operating condition, but no wireless client associated
Blue	Normal operating condition, at least one wireless client association
Operating status	Blinking blue	Software upgrade in progress
Cycling through green, red, and off	Discovery/join process in progress
Rapidly cycling through blue, green, and red	Access point location command invoked
Blinking red	Ethernet link not operational
Boot loader warnings	Blinking blue	Configuration recovery in progress (MODE button pushed for 2 to 3 seconds)
Red	Ethernet failure or image recovery (MODE button pushed for 20 to 30 seconds)
Blinking green	Image recovery in progress (MODE button released)
Boot loader errors	Red	DRAM memory test failure
Blinking red and blue	FLASH file system failure
Blinking red and off	Environment variable failure
Bad MAC address
Ethernet failure during image recovery
Boot environment failure
No Cisco image file
Boot failure
Cisco IOS errors	Red	Software failure; try disconnecting and reconnecting unit power
Cycling through blue, green, red, and off	General warning; insufficient inline power

您的这种状态，有无检查过电源供电情况？POE和电源注入器都试过了吗？Console都无输出，如果都测试了，我觉得应该RMA了。{:2_26:}

[LxL9905]

没有正常启动

[sufee]

AP3702i通电开机LED一直白光