04-08-2015 02:43 AM - edited 03-01-2019 04:49 AM
Hello, is it possible to establish a PORT CHANNEL between a couple of Cisco 6500 running VSS mode and a couple of NEXUS 5000 running vPC? . Design should be " Back-to-Back" : VSS-- Port-Channel--vPC.
I want also to support L2 and L3 flows between the two couples.
I read many forums but i am not sure it runs.
Is such design, if it runs; supported by Cisco?
Thanks a lot for your help.
04-20-2015 03:19 AM
Hi Tlequertier,
We have VSS 6509Es with Sup 2Ts & 6908 modules. These have a 40gb/sec (4 x 10gb/sec) uplink to our NEXUS 5548UP vPC switches.
So we have a fully meshed ether-channel between the 4 physical switches (2 x N5548UP & 2x6509E)
Kind regards,
Tim
04-22-2015 07:31 AM
Tim, thanks a lot for your answer.
I'm not quite in same config (SUP720 instead of your SUP2T) but i think / i hope it could do no differences in this area (VSS-"port-channel" -vPC)
04-22-2015 03:55 PM
Not a problem, we had the same scenario working with VS-S720-10G (Sup 720 3c) before we replaced them with Sup2Ts so I can confirm it works with them too.
Kind regards,
Tim
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide