Hello All,
Would like to consult here for a output from APIC for "show endpoints ip <ip address> ". Users were reporting some issue of slowness between 02 IPs (10.10.4.8 and 10.10.128.8) .
We observed that - for a IP we are getting multiple dynamic endpoints entries(03), However for other IP we see single dynamic endpoints entry(01). Guess this is nothing to do with slowness issue but just curious to know What this behavior indicates.. shared in below output from APIC.
APIC01# sh endpoints ip 10.10.4.8
Legends:
(P):Primary VLAN
(S):Secondary VLAN
Dynamic Endpoints:
Tenant : ABCD1
Application : ABCD1_app
AEPg : EPG-ABCD4_10.10.4.0
End Point MAC IP Address Node Interface Encap Multicast Address
----------------- ---------------------------------------- ---------- ------------------------------ --------------- ---------------
AX:11:BX:X1:X2:X3 10.10.4.8 vlan-4 not-applicable
AX:11:BX:X1:X2:X3 10.10.4.8 vlan-4 not-applicable
AX:11:BX:X1:X2:X3 10.10.4.8 110 111 vpc Policygvpc_gwa_FIA_ucs2 vlan-4 not-applicable
Total Dynamic Endpoints: 3
Total Static Endpoints: 0
+++++++++++++++++++++++++++++
APIC01# sh endpoints ip 10.10.228.8
Legends:
(P):Primary VLAN
(S):Secondary VLAN
Dynamic Endpoints:
Tenant : ABCD1
Application : ABCD1_app
AEPg : EPG-ABCD228_10.10.228.0
End Point MAC IP Address Node Interface Encap Multicast Address
----------------- ---------------------------------------- ---------- ------------------------------ --------------- ---------------
AX:14:BX:00:00:X1 10.10.228.8 110 111 vpc Policygvpc_gwa_FIA_ucs2 vlan-228 not-applicable
Total Dynamic Endpoints: 1
Total Static Endpoints: 0
APIC01#
And what need to be checked at ACI level to isolate the slowness problem (If any) between specific host and between all hosts.
Rgds
