cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3121
Views
6
Helpful
2
Replies

Cisco ACI BFD configuration

Daniel Blanco
Level 1
Level 1

Good Morning,

I have configured BFD over BGP to connect with Cisco 6500 for testing. I have checked all parameters in ACI and 6500 also and looks ok. I have read information about limitations in ACI for this protocol in order to Leaf and Spine models. My ACI is in 4.2 version with N9K-C9336PQ spine and N9K-C93180YC-EX leaves (starter kit). Connectivity between leaves and Cisco 6500 is in VPC mode (ACI side).

Somebody sounds this issue ? Kindly appreciate any help :).

Thank you very much !!

Best Regards,

1 Accepted Solution

Accepted Solutions

Hi Sergiu,

Forgot model spine and leaf models. This is a misunderstanding by me (read a very old documentation). I´m gong to check your document just in case I,ve forgotten some parameter. 

Many thanks !!

KR,

 

View solution in original post

2 Replies 2

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Not sure what do you mean by "in order to Leaf and Spine models". However, BFD is supported for L3Out:

https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/guide-c07-743150.html#L3OutBFD

 

Stay safe,

Sergiu

Hi Sergiu,

Forgot model spine and leaf models. This is a misunderstanding by me (read a very old documentation). I´m gong to check your document just in case I,ve forgotten some parameter. 

Many thanks !!

KR,

 

Review Cisco Networking for a $25 gift card

Save 25% on Day-2 Operations Add-On License