Spine Endpoints

[Ziad El Achkouty]

Is there another command than "show endpoint" to check the endpoints of the Spine?

[sateeshk10]

you don`t connect endpoints to spines only leafs are connected to spine.

you mean, want to see leafs connected to spine?

Regards

Sateesh K

[Ziad El Achkouty]

What I mean is that shouldn't endpoints connected to Leafs show in the endpoints of the Spine ? 

[Jenny Ngo]

Hi Ziad,

Endpoint tables are local to each switch. So if you view an endpoint table from one switch, you will only see the locally attached endpoints. Therefore, when you run the command on a spine, you will not see any endpoints since there are no endpoints connected to a spine.

If you would like to see a "global" view of all endpoints on all switches, you can run show endpoint command from the APIC.

Please let me know if that's what you were looking for.

- Jenny

[sateeshk10 · Accepted solution]

Hi Ziad,

you can try by using coop commands to get endponts on spine.

   show coop internal info ip-db

Thanks

sateesh K