If you add a Standby APIC to the ACI infrastructure, you might get confused as I was.
- The Standby APIC is shown in the System - Controllers topology, but serial number is shown instead of the name.
- In the System / Controllers view, you will see only the active APIC clusters and not the standby one.
- If you try to log into the Standby APIC, your default credentials will not work. You need to log in with a "rescue-user" account without any password..
- After logging to the Standby APIC, a banner will up saying, that Fabric discovery is in progress.
Don't get confused about the status.
- You need to highlight any of the active APIC nodes and choose the "Cluster as Seen by Node" option. Upon this, you will see both the active and Standby APIC nodes and can also replace an active with the standby.
- On any of the APICs, you can use the "show controller" command, which will also list the Standby APIC.
The behaviour is described in the Cisco APIC Getting Started Guide, Release 3.x, as well as the replacement procedure.
Regards,
Alexander
Here's a GUI screenshot of the System / Controllers GUI without the Standby, that confused me.
![System-controllers-status.jpg System-controllers-status.jpg](https://community.cisco.com/t5/image/serverpage/image-id/37992iDE541A54606D8098/image-size/large?v=v2&px=999)