11-19-2019 12:35 AM
Good Morning,
We are trying to configure PIM inside fabric (without external L3 itcx), but doesn´t work. We have deployed 4.0(3d) release and we have seen PIM with static RP is supported from this version. Have somebody configured it sometime ?
Thank you very much !!
Regards,
Solved! Go to Solution.
11-21-2019 07:20 AM
Cisco Live. Multicast in the ACI fabric - BRKACI-2608
11-21-2019 05:46 AM
We have multicast feed sources, subscribers and RP all in fabric, including source and subscribes in different tenant / VRFs. Works as expected. ACI v 4.2.1g
11-21-2019 06:45 AM
Hi,
Thank you very much for your response. I know multicast PIM is supported and inter-VRF also. I´ve asked Cisco and they have confirmed that is mandatory configure L3Out with Loopback into multicast domain inside the fabric. My question is about know how configure it step by step.
Regards,
11-21-2019 07:20 AM
Cisco Live. Multicast in the ACI fabric - BRKACI-2608
11-21-2019 08:17 AM
One more thing : for VRF to VRF multicast is a MUST to have source VRF on the SAME leaf where you have receiver (and receivers' VRF).
So if you have subscriber (receiver) on Leaf111 VRF1 and feed server on Leaf222 VRF2 and NO end-points for VRF2 in Leaf111, there will be no VRF2 in Leaf111, multicast wont work. You need to create fake endpoint on Leaf 111 to spin VRF 2 there.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide