- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-19-2011 10:05 AM
Hi All,
We have a requirement where-in hosts within the same vlan need to access each other on their public addresses. Can this be achieved using the ACE or the FWSM or any other Cisco device? Any help on this issue would be much appreciated.
Regards,
Nilesh
Solved! Go to Solution.
- Labels:
-
Application Networking
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2011 10:12 AM
Hello Nilesh,
If the servers are layer 2 adjacent behind the ACE, you can source NAT the server to server traffic to the public IP's assuming you have an extra IP on the same segement that the ACE would be configured to source nat the connections to.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2011 10:12 AM
Hello Nilesh,
If the servers are layer 2 adjacent behind the ACE, you can source NAT the server to server traffic to the public IP's assuming you have an extra IP on the same segement that the ACE would be configured to source nat the connections to.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-24-2011 09:46 AM
Hi thank you for reply. It pointed me in the right direction.
Regards,
Nilesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-23-2011 09:52 AM
Hi.. I cannot get working. Could you provide a sample config for this please?
Regards,
Nilesh
