cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
193
Views
0
Helpful
3
Replies
Beginner

ACE Configuration Synchronization failure

I have defined the FT group on ACE, but i don't see configuration getting update on the other module.

The response for 'sh ft peer detail' is as follows

Peer Id : 1

State : FSM_PEER_STATE_DOWN

Maintenance mode : MAINT_MODE_OFF

FT Vlan : 200

My IP Addr : 1.1.1.1

Peer IP Addr : 1.1.1.2

Query Vlan : Not Configured

Peer Query IP Addr : 0.0.0.0

Heartbeat Interval : 200

Heartbeat Count : 20

Tx Packets : 0

Tx Bytes : 0

Rx Packets : 0

Rx Bytes : 0

Rx Error Bytes : 0

Tx Keepalive Packets : 0

Rx Keepalive Packets : 0

TL_CLOSE count : 0

FT_VLAN_DOWN count : 0

PEER_DOWN count : 1

SRG Compatibility : INIT

License Compatibility : INIT

FT Groups : 1

Please assist.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Enthusiast

Re: ACE Configuration Synchronization failure

Can you please paste you configuration.

Did you configure both modules with the FT configuration?

Is the FT vlan available on both chassis?

Is the FT vlan trunked between the two chassis?

3 REPLIES
Highlighted
Enthusiast

Re: ACE Configuration Synchronization failure

Can you please paste you configuration.

Did you configure both modules with the FT configuration?

Is the FT vlan available on both chassis?

Is the FT vlan trunked between the two chassis?

Beginner

Re: ACE Configuration Synchronization failure

Your first question was the answer. VLAN was missing on the second chassis.

Thanks.

Enthusiast

Re: ACE Configuration Synchronization failure

you're welcome.

CreatePlease to create content
Ask the Expert- Webex Hybrid Services Solutions