Hi all,
I did a "ft switchover all" on the primary unit in order to reboot it afterwards, and I get the above message.
Group ID 2 does not switch over.
All contexts in the primary are active and in the secondary standby_hot before I attempt the switchover
--------------------------------------------------------------------
ACE4710Primary/Admin# sh ft group brief
FT Group ID: 1 My State:FSM_FT_STATE_ACTIVE Peer State:FSM_FT_STATE_STANDBY_
HOT
Context Name: Admin Context Id: 0 Running Cfg Sync Status:
Successful
FT Group ID: 2 My State:FSM_FT_STATE_ACTIVE Peer State:FSM_FT_STATE_STANDBY_
HOT
Context Name: VC_XXX Context Id: 1 Running Cfg Sync
Status: Successful
FT Group ID: 3 My State:FSM_FT_STATE_ACTIVE Peer State:FSM_FT_STATE_STANDBY_
HOT
Context Name: VC_YYY Context Id: 2 Running
Cfg Sync Status: Successful
FT Group ID: 4 My State:FSM_FT_STATE_ACTIVE Peer State:FSM_FT_STATE_STANDBY_
HOT
Context Name: VC_ZZZZ Context Id: 3 Running Cfg Sync
Status: Successful
----------------------------------------
after the switchover Group id 2 remains active on the primary unit
Any ideas why a group does not switch?
