05-19-2011 01:51 AM
Hi,
I would like to know whether CIsco ACE MODULE can be configured in such :
CLIENTS : 10.10.10.X
ACE VIP : 10.20.20.20
SERVER 1 ACTUAL IP : 10.20.20.21
SERVER 2 ACTUAL IP : 10.20.20.22
Both the VIP and Server are in one segment. This segment also are behind FWSM and in the same chassis.
Thanks in advance.
Rama
Solved! Go to Solution.
05-20-2011 12:56 AM
Hi Rama,
I'm afraid I cannot answer any of the two questions without first seeing a diagram of the exact topology you are planning to implement.
For the configuration example, I would recommend you to have a look at http://docwiki.cisco.com/wiki/Basic_Load_Balancing_Using_One_Arm_Mode_with_Source_NAT_on_the_Cisco_Application_Control_Engine_Configuration_Example
Regards
Daniel
05-19-2011 03:45 AM
Hi Rama,
Yes, it would be fine to use this kind of setup. You just need to take into account a few points points:
Let me know if you need more clarification on any of the points.
Regards
Daniel
05-19-2011 04:11 AM
Hi Daniel,
The traffic towards the ACE, can it be achieved if the ace context is parked behind the FWSM, and the context itself points the gateway to FWSM.
And for Source NAT, can I also use back the same segment VIP and server segment?
Appreciate if you could give me a sample config on this.
Many thanks
Rama
05-20-2011 12:56 AM
Hi Rama,
I'm afraid I cannot answer any of the two questions without first seeing a diagram of the exact topology you are planning to implement.
For the configuration example, I would recommend you to have a look at http://docwiki.cisco.com/wiki/Basic_Load_Balancing_Using_One_Arm_Mode_with_Source_NAT_on_the_Cisco_Application_Control_Engine_Configuration_Example
Regards
Daniel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide