Application Networking

I've been receiving the error below on a few WAVE appliances running version 4.1.5c.  Can you give an explanation of the problem and offer a solution?  Thanks.%WAAS-CMS-0-700002: ce(DataFeedPoll): java.lang.OutOfMemoryError: unable to create new nati...

We have a clustered AXG and the ACE 4710 configured for the load balancing.  The ACE is configured to LB for the VIP pointing to both AXG's and web site the AXG's filter for is another VIP.   The LB config works fine..and the AXG with Manager configu...

Hi.I'm sy jeonI wonder if the cisco WAAS support 802.1q.We are planing to attach the cisco wae to ethernet switch.as you know, we should configure the two vlan to WAE, one for PBR, wccpv2, other to return the traffic to router.if so,How can I configu...

hello,I'm working on getting my ACE modules to load balance PPTP traffic between two servers.In the initial setup I want all traffic to go to one server. Below is my initial configuration but itjust is not working. Does anyone have any ideas on what ...

Hi,I would like to know if the ACE supports multi domain SSL certificates.I have a VIP with multiple websites behind with different domains (www.abc.com, www.def.com...), so a wildcard certificate is not usable for me.After some research I found Mult...

I am trying to set-up SSL stickyness using the session ID in a onearm configuration mode and can not access the website via the vip.  I can browse to both servers directly.The ACE is connected to a Cat 6500, via a 4 gigabit ethernet port-channel and ...

Hi,I've tried to installed the license, but is not successful, below are the steps which i've taken to installed the license, with error messages. pls. assist.CBJ6-LBDMZ2/Admin# copy tftp://10.2.18.66/ACE20090909090659371.lic disk0:Enter the destinat...

I'm going to implement WAE (274, 474, 574, and 674) in inline mode at remote locations where the WAN devices are a server running Microsoft Firewall and VPN software. The Microsoft server functions as WAN firewall device and also VPN termination devi...

Hi there. Hope you can help.I have just installed 2 ACE 4710 load Balancers into a 42U HP rack. We have mounted the railsthat came with the 4710's in the racks as specified. However, when we slide the uniservert into the rails it does not go fully ho...

Hi,I would like to ask regarding the configuration for the backup rserver with sticky configured.  /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-no...

You've all probably seen this before. Very entertaining though See attached

We are about deploying WAAS for a client , we notice the Cisco switch 6506 we plan to config WCCP ver 2, the switch is running Cat IOS Version McpSW: 5.5(1): we notice it support WCCP ver 2, but on the interface it can only support ip wccp 6x redirec...

I am looking to solve a design which has to work in two scenarios. Preferably with an in-line solution. 1. Transparent design with VRF on both sides: FW-VRF (Subnet A)      |      | (VLAN 11)      | ACE (Subnet A)      |      | (VLAN 12)      |LAN-VR...