Hi all,I am new to the CE device. I am being told by Websense support I need to upgrade websense which is onbox on the CE device. I am unable to find anything on CCO on how to do this and websense support is not being much helpThanks
My client want CE in proxy mode (all users browser's proxy setting will point to CE) and some features I read is still unclear. 1. If the CE is not able to fetch the content, can CE get it from another proxy with port say 8080, with auth entication? ...
I have 2 CSS11501's configured with redundancy between them. On certain occasions I am noticing that the master is becoming the backup for a very short period of time, I think it is due to the fact that CPU utilisation on the master or backup is gett...
Hi,I wonder how an IOS router chooses WCCP Router-Id. I didn't find any information regarding this question.We have configured 2 router with same IP Address on Loopback 0, and router chooses this IP Add as WCCP Router-ID. Cahces reports error in log ...
Is it possible to connect a server with two NIC's to the CSS so the server has a 200Mb connection to the CSS?The server will be a SUN Solaris with IPMP enabled for multipathing.Thanks in advance,Edwin
Is there any way to pass real client's IP to the server when the client's IP is being source NAT'ed via group- destination-service? CSS is working in one-armed configuration.
below is the sh snmp output from my local director. I run snmpwalk and it coudn't connect to the device. Do i miss something..I basically want to enable SNMP on local director to view the bandwidth..snmp-server host 10.X.X.Xno snmp-server enable trap...
when I run "show log" or "show script", I got nothing. It seems that there is nothing on the disk or the disk don't exist on the CSS11150. But the "show disk" show there is a disk on the CSS and there was always some script file and log files on the ...
Can anyone see what is wrong with my source-group, “skylar”? I am trying to use it to do a source address translation from the real address: 172.24.0.58 to the virtual address 172.24.1.72.The real host, 172.24.0.58 is connected directly to the css, o...
In testing my backup configuration, I can take my primary real oos and my failover comes up just as it is intended to do. But, if I simulate a hardware failure on the primary, the failover doesn't come up.In searching through the forums, I've come a...
Can you explain what the following entries in my sys.log file mean? These 2 lines are repeated a few times in the log file. (WebNS version 07.30.0.05):OCT 25 09:23:53 1/1 118420 SYSSOFT-4: Communications-QUEUE FULL-Ipv4SlaveArpTx: Internal Messages D...
Hi,I want to configure firewall load balancing as follows. I have 3 firewalls, FW1, FW2, FW3. I want to create a serverfarm for each FW, i.e. FW1 in SF1, FW2 in SF2, and FW3 in SF3. Then, we'd like to create two Virtual server VS1 and VS2. Each Virtu...
Hi all, Our customers have asked if it is possible with our current CSS, to let the CSS act as a SSL termination deviceSo that the webservers get less burden, just plain httpAs far as I understand it, you have to order a 11501 immediately with the SS...
I have a CSS11503 running s/w version 7.10 Build 504.The problem I am having is that wehn the CSS detects webservice has failed and marks it as down, The CSS does not recognise when the Web Service comes back online. We have to manually go intio the ...
