Cisco APPNAV Controller module on the WaaS - deployment
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2013 10:59 PM
Hi, I am using WaaS for a long time now. With the new appnav module on the waas box, i am little confused about how to deploy. I have two WAN router connected to two firewalls in HA through L2 switches. I have two WaaS boxes in-line between the L2 switch and WAN routers and it's working so far!
Now i am upgraging the WaaS setup and i am having three 8541 WaaS box with appnav module on it and want to deploy them. What the best design deployment should i go for?
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2013 01:17 PM
Pradyetendu,
As a Cisco partner, you have access to additional resources including some training material
Partner WAAS Community Site.
https://communities.cisco.com/community/partner/datacenter/products/waas
WAAS 5.0 Training Material
https://communities.cisco.com/docs/DOC-30438
Partners with proper certification and specialization may also engage with PDI Helpdesk.
Appnav can be deployed inline or offpath. Note that appnav interfaces do not fail open as the inline modules do. You will want to consider this in your design.
Thank You,
Dan Laden
Cisco PDI Data Center
Want to know more about how PDI can assist you?
http://www.youtube.com/watch?v=4BebSCuxcQU&list=PL88EB353557455BD7
